The model of the spray dust suppression vehicle is closer to that of an ordinary truck, but the dust suppression effect it can achieve is indeed better. The efficiency of spray dust suppression vehicles is comparable to those of ordinary sprinklers. The efficiency of the former is higher than 30 times that of the latter. The working diameter of a spray duster can cover up to 4 standard football fields. Water in the vehicle tank is sprayed out of the high pressure blower after the atomization process. Compared with those of ordinary sprinklers, the water and mist particles that they spray are extremely small, can reach the micron level, and the adhesion can also be increased by 3 times, but it can reduce the water consumption to 100%. seventy. Regular maintenance to maintain the air cleaner of the spray dust suppression car can well prevent abnormal or premature wear of the vehicle's engine and maintain a good working condition. The daily air filter maintenance methods for spray dust suppression vehicles are as follows:
1. The main function of the air filter of a spray dust suppression car is to filter out the carbon, dust, and other debris contained in the air, as well as part of the water vapor, so that the air can be better ensured and cleaned. In the cylinder. In general, about 10,000 units of clean air are used for each unit of fuel burned. Vehicle manufacturers will have recommended that the normal maintenance cycle of the air filter is about 48,000 kilometers. It is necessary to do a routine inspection and maintenance every time it reaches 24,000 kilometers. .
2. The atmosphere in which we live is basically particles with three different densities: carbon particles, dust, and debris. On those open roads, the dust content is lower than in the urban construction areas and in the countryside. The bolder dust concentration is in the construction site or in the sand area. If the spray dust suppression vehicle is used for a long time in such an environment, the frequency of inspection and replacement of the air filter will be more frequent than in other places. In those with poor traffic conditions and highways, because the vehicle emissions are more concentrated, so the carbon content in the air is also relatively high. At this time, regular inspections should also be conducted. During the filter inspection, we carefully look at the depths of the wrinkles. The filters that may be sprayed on the dust filter seem to be clean on the outside, but the content is already very dirty. It should be cleaned and replaced immediately.
Gate Valves are called "full-flow" Valves; there's a direct unobstructed path for flow right through the middle of the valve. A wedge-shaped brass gate is lowered into a machined slot to close the valve. They should either be completely open or completely closed. Water flowing through a partially open gate valve wears away the metal and causes the valve to fail over time.
Gate Valves
Brass Gate Valve, Flanged Gate Valve, High Pressure Gate Valves, Water Gate Valves
ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.kingsirvalve.com