2, Â On the tanker truck tanker inlet pipe branch line should not be increased. The two pumps of two dispensers or two-gun dispensers cannot share one branch of the oil supply.
3 , Â After the new pipeline is installed, clean mud, iron scraps and other debris in the pipe should be cleaned before installing the tanker to prevent dirt from entering the tanker and damaging the machine.
4, Â After the first oil delivery, the filter of the oil pump should be inspected and cleaned to prevent the flow of oil from drastically reducing and damaging the hydraulic components due to filter clogging.
5, Â At the flange of the refuelling oil pipe, an oil-resistant seal must be used.
6, Â The power must be cut off during maintenance, and must not be checked with electrification. Do not scratch the explosion-proof joint surface when opening the explosion-proof electrical box. When removing the explosion-proof chamber, the dirt should be removed and clean the explosion-proof joint surface; the cable seal should be good, metal Washers and gaskets must not be lost. The number of screws must not be missing to ensure the explosion-proof performance of the electrical parts.
7, Â When using self-provided generator power supply, be sure to wait until the generator runs smoothly and then supply power to the fuel dispenser. Ensure that the voltage is within 220V-15 % to 220V 10% or 380V-15 % to 380V 10% to avoid generator start-up. When the peak voltage burns out computer components.
8, Â When the tanker is installed outdoors, there should be a canopy above the machine to protect the machine from rain and sunlight.
9 , Â When making electrical connections or repairs, the relevant power of the tanker should be cut off before proceeding.
10, does not allow untrained personnel or authorized the construction and operation of tankers.
High Speed Cut To Length Line focus on introducing high speed stop shear cut to length line and flying shear cut to length line. High speed means high productivity.
- Thin sheet requires high speed, because length of thin coil sheet will be thousands of meters, the cutting time of each coil will be too long if line speed is too low.
- when length of finished sheets is short below 1m, fly cutting is more suitable
- when length of sheets is longer over 1m, high speed stop cutting is more suitable.
- Each high speed cut to length line is custom made, we hope customers can tell us his requirements clearly.
- We supply high speed CTL lines to Malaysia, KSA, Algeria, USA, etc. countries.
High Speed Cut To Length Line,High Speed CTL Line,Precision Cutting To Length Line,High Speed Aluminum Fly Cutter
Wuxi Jinye Complete Set of Equipment Co.Ltd. , https://www.machinejinye.com