First, the rational use of flotation machine equipment
1, to evenly give the mine, not excessive.
2. Control the concentration of the pulp and the agent.
3. Adjust the intake air volume.
4. There should be no wood chips, rags, etc. in the flotation cell.
5. When parking, you must park in the ball mill for 20 minutes before parking.
Second, the preparation and inspection of the flotation machine before operation
1. Whether the screws on the frame, motor base and main bearing are loose.
2. Whether the tank body leaks.
3. Is the scraper and scraper shaft intact?
4. Is there any debris in the tank?
5. Whether the slurry pipe is unobstructed.
6. Is there any oil at each lubrication point?
7, the V-belt should be suitable.
8. Whether there is looseness in the pulley installation.
9. Does the V-belt have broken marks?
10. Is the switch box knife gate intact?
11. Whether the screws and joints of each part are good.
Third, the operation method of the flotation machine
(1) Driving sequence
1. Close the switch box knife gate.
2. After moving the pulley by hand, it can be started after being light and unobstructed. Press the start button and pay attention to the sound of the motor.
3. Start the scraper motor and wait until everything is working properly.
(two), parking sequence
1. When parking, stop the motor rotation after stopping the ball mill for 20 minutes.
2. Stop the scraper motor and pull down the switch box knife gate.
3. When there is no notice of power failure, pull down the switch box.
The Loader linkage rod is the part connecting the Rocker arm of loader and the Loader Bucket. The pull rod of different models is mainly different from the center distance of two holes and the inner diameter of two holes
Structure of Loader Working Device
The working device consists of bucket, boom, beam, support, rocker arm, pull rod and so on. Each member is connected by hinge pin and has relative rotation. In order to enhance the stiffness of rocker arm and support, there is a rib plate connection between rocker arm and support, which can be regarded as a whole in calculation. The upper hinge point of the boom is hinged with the front frame of the loader, and the middle hinge point is hinged with the lift cylinder; The upper hinge point of the rocker arm is hinged with the bucket cylinder. In finite element static analysis with MARC, it is found that there is no relative rotation at each hinge of the working device. The boom is the main force component of the working device, and its section shape is rectangular.
Liugong Loader Linkage Rod,Sdlg Loader Linkage Rod,Sem Loader Linkage Rod,Lonking Loader Linkage Rod
Henan Hanfeng Construction Machinery Co., LTD , https://www.hf-loaderparts.com