What are the maintenance and repair of K-ZN-P ultraviolet aging test chamber?
一ã€Introduction of UV aging test box
Applicable to a variety of industrial products performance reliability test, with reference to GB/T14522-1993, GB/T16585-1996 and GB/T16422.3-1997 and other related standard terms of design and manufacturing. It meets the UV aging test standards of ASTM D4329, D499, D4587, D5208, G154, G53, ISO4892-3, ISO11507, EN534, PREN1062-4, BS2782, JISD0205, and SAEJ2020.
Second, UV aging test chamber maintenance
1. Keep the appearance of the box clean and tidy; avoid dust intrusion into the box;
2, to avoid external forces hit the box;
3. Prohibit chemical exposure to the equipment;
4, the laboratory to keep the instrument dry;
5. Absolutely prohibit the setting temperature from exceeding the maximum temperature specified by this equipment;
6, the UV aging test box before each boot before checking the circuit control system;
7. Confirmation of power supply and grounding wire;
8. Whether the power cord is properly connected according to the specifications and is indeed grounded;
9. Check whether the over-temperature protector has been set (it has been adjusted when leaving the factory, generally no adjustment is needed);
10. Ventilation fans should be installed in the laboratory to maintain indoor ventilation;
11, UV aging test box spray test should pay attention to observe the water level of the tank, and timely replenish pure water;
12. The equipment's wastewater discharge system must be installed in place;
13, after the end of the test, the whole power off;
14. After the end of each test of the UV aging test box, the sample should be taken out and the equipment liner should be cleaned;
15. Non-professionals are prohibited from operating this equipment.
Suzhou Keitel equipment manufacturers specializing in the production of: electric constant temperature water bath, electric constant temperature oil bath, aging test chamber, ventilation aging test chamber, high and low temperature test chamber, UV aging test chamber, resistance to ozone aging test chamber cross-linked cable slicing machine, Cable specimen flaker, insulation sheath punching machine, wire winding torsion testing machine, cable and three-wheel bending tester.
Wide range of straight three-hole-blades (3-Hole) optimized for cutting in different materials. We coat Razor Blades to protect the blade from abrasion, to reduce friction, and increase performance and durability.
Wide variety of rounded three-hole-blades optimized for cutting in different materials. In order to reduce the risk of shears in the blade, we recommend using straight 3 hole blades, rather than rounded ones. The industrial razor blades are available in different versions in order to be better suited for different materials.
Three Hole Blades,Double Edged Sword Blades,Double Edged Long Sword,Double Edge Blade Sharpener
Ningbo Jiangbei Chuangjia Stationery Factory , https://www.cjblade.com